Water fountain, Peacock

Transform a favorite garden spot into an artful retreat with this unique, stylish Bird Metal Water Fountain. It was crafted from iron and makes a subtle accent piece.
* Enjoy the sights and sounds of your feathered bird friends as they dip into the crystal waters of this graceful metal fountain.
* This handsome focal piece is an ideal centerpiece for any garden, patio, or deck!
* Adjustable water flow on each crow or bird.
* The pump is powered by electricity and fulfilled AS/NZS 4417.

Technical Details:
Material:iron
Surface treatment:powder coating
Electrical pump: Type SAA333
Operating voltage: 230W, 50Hz, motor power 2.5W, protection class IPX8
Size:14.5"×19.5"×34.5"H

Assembly:

Before beginning the assembly of the spring please check if the set is complete. The set consists of the following listed parts:
. 1 large spring bowl (1)
. 1 sculpture (2)
. 1 pump with power cord and plug (3)
. 1 plastic adaptor at the pump (5)
. 1 short piece transparent hose (6)
1. First fit the transparent hose (6) on the plastic adaptor (5). Put it with the other end into the designated hole at the pump (3).
2. Now put the pump (with the adapted hoses) into the spring bowl (1). The upper end of the hose has to besituated directly under the little opening of the spring bowl.
3. Plug the fish sculpture (2) through this little opening. Fix the pump with the suction cups at the bottom of the spring bowl. Pay attention that the water basin is free of dust and debris before you fix the pump in the water basin.
4. After all please place the tripod grid (4) with the grid upwards into the big round opening of the bowl.
5. Fix the fish sculpture (2) with the butterfly screws. Consider that the mouth opens to the middle of the bowls big round opening!
6. Then pull the power cord with its plug through the little square opening without removing the pump from its adhesive position.
7. Now you can fill the spring bowl with water.
Please use distilled water only, temperate between +5℃ and max. +35℃。
8. Important: Ensure that the pump is submerged completely into the water and the grid of the tripod grid set is above the waterline!
9. Please plug the mains plug into a power socket. The spring starts running and pumping water through the mouths. Initially, there may still be air in the pump and hose that impairs its operation. In this case, repeatedly insert the power plug into the socket until the pump begins to operate.
. You can set the flow rate of the water with the interval switch at the side of the pump housing
(See Fig.). ATTENTION: Ensure you have pulled the mains plug out of the power socket before!
. Remove the power plug from the socket again to disconnect the pump.

IMPORTANT NOTES
. ATTENTION! NEVER insert the power plug into the socket if the fountain container is empty or the pump is not completely covered with water!
It is important to prevent the pump from running dry to avoid any damage! Always fill the fountain with water BEFORE operating the pump through inserting the power plug into the socket. DO NOT USE THE PUMP WITHOUT ANY WATER!
. The fountain and its electric pump are ONLY suitable for using with water! Only use fresh, clean water to fill the water basin! The temperature of the water may not exceed 35℃!
. Do not fill any flammable liquids into the water basin!
ATTENTION: ALWAYS pull out the power plug when cleaning and maintaining the pump!